mach 1 vs ss/tc?
Thread Starter
New Member
Joined: 06-16-09
Posts: 191
Likes: 0
From: toledo
He won't have the car before im tuned which is before I pull the car out of storage in the spring. If he finds out cool other words if I race someone and they ask I will tell otherwise not going to worry about it.
Senior Member
Joined: 02-27-09
Posts: 4,797
Likes: 0
From: Climbin In Your Window...
New Member
Joined: 03-22-07
Posts: 60
Likes: 0
From: Savannah, Ga
The average Mach 1 with a 5spd I have seen runs in the 13.3-13.4 range, average 05+ GT with a 5spd is in the 13.5-13.6, not much of a difference. I think the OP is done from a dig, if the guy knows how to drive and is used to a 5spd, and from a roll I cant see the SS/TC pulling by much, if any.
New Member
Joined: 08-12-09
Posts: 38
Likes: 0
From: Texas
Don't hustle unless it's for money. And don't give any bs excuses if you lose. If you lose, your car's slower, big ******* deal, don't cry about it. This wasn't just to the OP, it was to some other kids too, lol.
If you get a tune before then, then you should beat him. Especially with him having to learn about what tire spin is.
If you get a tune before then, then you should beat him. Especially with him having to learn about what tire spin is.
New Member
Joined: 06-26-08
Posts: 116
Likes: 0
From: Eastampton/ Oakhurst New Jersey
I'd say the Mach 1 5-spd's were are a little stronger than the '05+ GT's especially in a roll race. The stock Mach's I've seen had no problem pulling on the newer GT's. They average mid to low 13's trapping 104-105 on a good night. He'd have a decent advantage on the Cobalt from a dig if he can drive, much closer from a roll.
Thread
Thread Starter
Forum
Replies
Last Post
camaromanss1992
Parts
3
Oct 1, 2015 10:51 PM