Lmaoo that just made my day!

 

wire brush. then a finer wire attachment on the dremel. then some polishing compound. took about an hour. went by fast honestly.

 

ahahahaha

 

 

 

the treeeeeee

spooky good

 

Marks or reflection on passenger door?

 

definitely a reflection of that fence

 

No, Very centre. White marks.. and bottom left. Under the reflection of said fence.

 

Dirt, Was doing some mountain runs each day and I was visiting a place that lived on a dirt road so each morning I drove out to a car wash and did a quick wash so it would look descent lol

 

Heres a few more

 

would anyone like a turbo to go with their fitment?

 

Ebrake had the rear jacked up a little from when I lowered it down on the jack but this is a good idea of where ill be next spring. 17x9.5 +38 255/40

http://www.flickr.com/photos/deebsr6/8121690265/http://www.flickr.com/photos/deebsr6/8121690265/ by http://www.flickr.com/people/deebsr6/, on Flickr

 

beastly

 

http://www.flickr.com/photos/bpacak/8123397436/
http://www.flickr.com/photos/bpacak/8123378743/
i need to stiffen up the rear, still have it on the whatever it came set on. and i kinda want to get a hardcore bar, probably buy one over winter. Oh and i dont like tire shine much, i dont even know why i bought it haha

 

And of course

MERICA!

http://www.flickr.com/photos/bpacak/8123378563/

 

on matte black wheels, tire shine gives it a weird look.

 

I called to order those in hyper silver and try said try won't so then anymore so bummed! Look good bpacak!

 

thats extremely hard to read, but thanks haha.

 

my thoughts exactly! ahaha Seb, you don't live on the Quebec side; type more betterer

 

slightly older, but relevant!

 

That's a sexy pic.

 

15x6 -3. 185/85/15










same style wheels are going on the front. and they'll all be flat black so the car will finally have matching wheels for the first time since late 2010.


and a little prototype piece on the car right now. none of you guys will need it since you want low haha. but i'll have two machined out of aluminum. 3/4" thick, 2 1/8" hole, 5.5"LxW with 1/2" notch. spacers to go under the rear springs so i can have more adjustability.

 

Best stancebalt out there IMHO

 

once i get the front wheels and slicks on there i can start adjusting things. i'm sitting at about 27 7/8" from ground to the bottom edge of the middle of the fender. and thats with coilovers all the way up maxed. so i've got tons of room to drop it down and play with it. i just want to wait till the fronts are on.