On my way back right now, my car quit and through a engine reduce power code. i let i pushed it 2 blocks and decided to start it up again, and it fired up.. but now i am throwing a code.. but i am unable to see it.. any ideas.. i have stage 2 and injen intake..

 

What year is it?

 

Limp mode?

 

my 05 did that a few times. the error code that i kept getting was related to two sensors reporting two temp readings that were out of tolerance... I cut the end of my intake off and never had the code again. (ebay intake). Not sure if you have ever thrown a code with your intake, but that would be a place to start. check all of the clamps and make sure that they are tight and that the MAF is plugged in securely.

 

i have an 06 is sitting at the dealership now.. so we shall see what happens.. I through a lean code with my intake when i first got it, which was a year ago, and never had problems since... and my car has been sitting at my p;s for 3 months, cause i was working out west, but they started it once a week..

Guess we will see what the dealership says...