Is it hard? Anyone done it? Any how to's or tips?

 

I have the sparco grips. I just had to dremel the gas pedal, the other 2 needed just a drill. They look gorgeous

 

yeah the gmpp pedals are actually replacements though, not covers. That's why I want to know info on those exact pedals.

 

ah ok, didn't know it. But just know that if you decide for the sparco, they won't look covers, they are really beautiful. I have them and they match perfectly my TWM with aluminum knob and my momo aluminum ebrake.

 

i have the GMPP pedals. make sure they are nice and warm. Like a hair dryer or heatgun will help During the install for the brake and clutch, and a racheting 10mm wrench will help for the gas pedal. Also, a small flathead will help get the brake and clutch on.

 

They are full replacements right? Where do you remove the stock ones from?

 

Gas pedal is a full replacement

Clutch and brake are covers the stock ones pull off and put new ones on. Like already said you'll need to warm them up so it'll be easier

 

Anyone have a part number for these?

Are they nice?

 

Here is a link to them:
Pedal Cover 12499876 - Crate Engine Depot

 

Like said before,,, have brake/cluth covers warm,,, have a little (couple of drops) of regular dishwashing liquid or liq, laundry detergent. Lubes the rubber/pedals to slip on easier and will not hurt the rubber covers or stay greasy like silicone or oil... Accellerator unit is not a cover but cover/shaft and box!! Bolts off and on as a unit! Very tite with a wrench,,, but have patience and a good back!!!,,, and it will go on fine!!!

GTO 1

 

My car came with them and yes they're nice. I like them a lot.

 

Yeah my SS/SC came with them but the SS/TC didn't


I will be getting them shortly because they really do spice up the look of the interior.