Looking to purchase an aftermarket intercooler. Any recommendations? Hahn or ZZP? Any feedback is helpful.

 

ZZP/fmic & there charge pipes & couplers all day everyday. I got the standard size. I'm on POWELL YYZ Springs & am not lowered. If i go straight out of driveways i do bottom out so you have to do the sideways exit thing unless you buy there smaller version for clearance(another 1/2 inch) I had a cracked end tank & a leak @ the seam of the lower charge pipe. I epoxied it with good success but was loosing my mind chasing a vacuum leak(pcv valve in intake mani wasn't checking). I've bottomed out like 10 times so far with no problems.The intercooler practically likes the abuse. Car definitely runs cooler as well. ZZP no further questions.

 

I run the modern performance one and re drilled holes a half of an inch below the existing holes and got more ground clearance than the factory

 

Zzp

 

I went zzp standard size with upper charge pipe from them. (Blew apart my stock plastic units). Very happy with both zzp pcs. I went standard size (stock size) iC as I did not want to worry about bottoming out on the bigger one. I would think 400whp and under should do just fine on this IC.