My old rotors and pads were **** so i bought new powerstop z23 evolution sport drilled and slotted brake kits front and rear. Me and my brother did it together we made sure everything was correct and lubed up really good. But for some they squeal soooooo loud when theyre cold, its not bad after they warm up and i brake slowly and when i do a hard turn or enter a steep angled driveway. I have really bad sway bar end links and control arms. I think they make noise too but only if its cold and or i enter a steep angled driveway. Everytime i fix a problem another pops up

 

Did u grease the back of the pad where the piston pushes? Other than that, performance pads sqeek usually.

 

Did you spray the rotors with brake clean to get rid of the protective coating before the install? That will cause squeaking.

 

yes,everything possible is lubed except the rotors and the side of brake pads that contact the rotor

 

no ill try that thanks

 

Probably not going to do anything now. The brake pads ground the film off and it is most likely now embedded into the pads

 

That sucks