AEM intake install 2.0
#1
Senior Member
Thread Starter
Join Date: 01-25-07
Location: glens falls
Posts: 734
Likes: 0
Received 0 Likes
on
0 Posts
AEM intake install 2.0
Hey guys, i just ordered an aem intake from cobaltperformaceparts.com , i was wondering if theres any special tools i should pick up to make the install go smoothly. any tips or advise?
oh also anyone think i should get a hydroshield?
oh also anyone think i should get a hydroshield?
#2
Member
Join Date: 04-03-07
Location: Independence, MO
Posts: 300
Likes: 0
Received 0 Likes
on
0 Posts
Simple tools garage should be ok. Nothing to hard to deal with really. Hardest part is getting the inner fender wall out. Just time consuming really. I definitly recomend a hydro shield of some sort, just to be safe. The K&N dry charger shield is very nice, i have it and love it on my K&N CAI. Plus its cheap to boot. Check it out on the K&N's website. Good luck!
#6
Senior Member
Thread Starter
Join Date: 01-25-07
Location: glens falls
Posts: 734
Likes: 0
Received 0 Likes
on
0 Posts
Well i got in on today, Sounds dyno-mite!!! really good and unique sounding car now with the gmpp exhaust. All in all the install wasn't bad at all probably took me two hours, from start to test drive!
On the way out to cruise some more, love the sound
Oh no Cels either
On the way out to cruise some more, love the sound
Oh no Cels either
Thread
Thread Starter
Forum
Replies
Last Post