Carstedts LSJ round 2
#28
Im spraying my built lsj...they really respond to it well...
just don't do 150 all at ones like i did...stretched the arp head studs and spun the tires on the dyno.
just don't do 150 all at ones like i did...stretched the arp head studs and spun the tires on the dyno.
#30
Senior Member
iTrader: (1)
Join Date: 10-17-10
Location: ft. lewis/ milwaukee, WI
Posts: 4,605
Likes: 0
Received 0 Likes
on
0 Posts
haha no i wont be doing that, the most i would spray would be a 100 shot, i wanna take the meth off and shoot a 50shot on the street. I think that would jus add to the fun of the car haha
#31
Junior Member
Thread Starter
Join Date: 12-13-11
Location: Wisconsin
Posts: 420
Likes: 0
Received 0 Likes
on
0 Posts
#33
Senior Member
iTrader: (1)
Join Date: 10-17-10
Location: ft. lewis/ milwaukee, WI
Posts: 4,605
Likes: 0
Received 0 Likes
on
0 Posts
lol brian the way it is when i get back is how it wil stay till im out of the army back in WI with my own garage again, then the fun will happen or we can bring it to james for the RPT meet next year haha
#34
Junior Member
Thread Starter
Join Date: 12-13-11
Location: Wisconsin
Posts: 420
Likes: 0
Received 0 Likes
on
0 Posts
yeah, I know, I'm still looking out for you to keep you from breaking it again lol
#40
Junior Member
Thread Starter
Join Date: 12-13-11
Location: Wisconsin
Posts: 420
Likes: 0
Received 0 Likes
on
0 Posts
#45
Yet tons of ppl used to swap pistons without balancing then wondered why it broke a couple thousand miles later.
And I was being sarcastic to see who was paying attention lol
90% of the ppl here will float right over it.
And I was being sarcastic to see who was paying attention lol
90% of the ppl here will float right over it.
#47
Junior Member
Thread Starter
Join Date: 12-13-11
Location: Wisconsin
Posts: 420
Likes: 0
Received 0 Likes
on
0 Posts
#48
Senior Member
iTrader: (1)
Join Date: 10-17-10
Location: ft. lewis/ milwaukee, WI
Posts: 4,605
Likes: 0
Received 0 Likes
on
0 Posts
ya theres no shortcuts on this engine, made sure the machine shop went through and checked everything and made sure it was all straight this time. Only thing i did not feel the need to do was the rods since i wont be over 500hp unless i shoot the nitrous with a bigger shot on it but i only bought the kit since i got a good deal on it but hopefully this thing runs like a raped ape when its done, i loved how it felt the 1st time and it wasnt even fully finished haha