Angel

Ok, we have mounted the OTTP stage 2 rotated tranny mounts and the steering rack spacers also from OTTP but we can find the torque specs for either. We need the specs for all the bolts on the tranny mounts(including bolts that go through the subframe center that mount to the rear mount and the specs for the bolts that go through the mount. We also have installed the steering rack spacers and cant find torque specs for the bolts that go through the spacers. Please help as we need this car mobile for tonight. Thanks ahead of time for all your help. Cheers!!

ff_drift_lol

35 ft lbs. hope I'm not too late

qwikredline

Support motor! loosen off slightly the top mount bolts to trans, passenger side and drivers side at the top; Install lower mounts, install rear mount first, insert keyhole spacer if stage 1. Hand tighten all bolts. Then install front mount. when the mounts are all installed and bolted up hand tight not torqued, then torque them: tighten rear mount to cradle 3 bolts 44 f tlbs; then rear cross bolt first; 74 ft lbs. then front mount to transaxle bolts 66 ft lbs.then front cross bolt74 ft lbs then re tighten the top mounts Tighten the transmission mount to transmission at the top, 37 ft lbs etc steering rack bolts are 81 ft lbs. I can send this information to OTTP for next time good luck

Frew

iTrader: (9)

when i put my solid poly mounts in i just torqued the bitches down with a half inch driver =-D

ff_drift_lol

good thing this guy chimed in. I was looking at a spec sheet off mitchell 1 it got wet so it looks like 35. mitchell says 85 but 81 sounds like a real service manual.

better safe than sowwy!

ssyellow

05-08-2009, 08:35 PM


"Please help as we need this car mobile for tonight"

....little late I think lol

Code5

How easy were the steering rack spacers?