hey i just got hp tuner and i wanted to know if someone could look over my tune real quick to see how it is
i was dyno tuned at a shop but i would like some other people to look at it
i haven't had time to log the car yet but i pulled the tune from the car
if you want to help me out let me know what you email address is so i can email the file to you
and i did post on hp tuners forum

 

Post it up here

 

how remember i just got it today
i dont know how to post files on here

 

I don't think you can here.

 

http://www.hptuners.com/forum/showthread.php?t=30126

there is a link to my hp tuner thread

i just posted some logs on hp tuner

 

whats wrong with the smg tune?

 

nothing really i just want some other peoples opinions on it
but it seems to stay to lean after i step on it

 

how lean is it running?

 

um kinda scary lean like i step on it and it stays in the 14s then starts to drop to wear it should be
maybe i have an exhaust leak that is throwing my wideband off

i have been to the track on the same tune and there was nothing wrong with it
the only thing i have done to the car sense getting tuned is a new fuel filter and change my oil

 

post up your final tune that you deem perfect! I would love to grab me an hp tuner and have a stepping stone, our mods are similar. How did you tune to the meth? advance timing after the meth kicks in?

 

i didnt tune it i had it done at a shop
i just got hp tuner today and want to start learning
i just wanted people to look at the tune that is on my car now

 

ok, sure fooled me.

 

your link has your tune and configs, but no logs

 

Depending on your PE settings, this is expected. By default, it doesn't richen up until 5500 RPM. Mine's set to 2500, a lot of people set it to 0.

 

Not to mention he has meth which you can get away with a ballsier afr.

 

ok i put one idle log on hp tuners forum that is all i saved right
and how do i change me pe to a lower rpni dont like how it is now

 

Engine>Fuel Control>Power Enrich>PE Enable> Delay RPM

 

 

Up your Enrichment Rate to 2.

 

correct me if i am wrong, but if PE MAP enable is set at 35 KPA ~ 5.07PSI, you still must subtract 14.7 PSI to tell you what boost it enables?

 

Correct. The way he has it now he can go into PE no matter what his boost is at, as long as his pedal is down enough (the TPS table) and he's above 1900 RPM.

 

so what does that mean is it something that needs to get change and what to
i have no idea what i am doing yet tuning wise

 

Do this for starters.
Then read this
http://www.ionforums.com/forums/tuni...ve-tuning.html

 

Thats a very good place to start^^^^^

 

i did that and i will read that now