So, before I post a possible fix for this, I need to gather some data.

I also forgot to add, Stock, Intake. But I am pretty sure that is not going to be the problem. Please post if it is.

 

just threw that code up, installed an injen CAI and all else is stock.... my car dropped down to running on 2 cyl and gave me that "reduced power", i pulled over turned car off then on and worked fine except for the MIL. got home and scanned it for the p0068 code. i started the car 5 hours later and MIL was gone...i'm gonna look into the problem sometime this week.

 

P0068 Throttle Body Airflow Performance ECM, PCM

mods might not be the problem

 

unplug your battery for about 30 minutes. I found out that a simple few minutes is not good enough. You should be fine. The code is a correlation among your SC inlet, Mass air flow, Map, and barometric sensors.

 

Yea im going to do that and clean the MAF aswell. im going to look and see if the throttle body is dirty...plus i found that my cat is shatttered haha thank you recall for going to be paying for that.

 

when i replaced the oil with water.