Working on a heat exchanger deal....
Senior Member
Joined: 01-05-06
Posts: 2,509
Likes: 1
From: Ft Lauderdale
I Did Mine>> I will Post up a few Pics tomorrow & Show you How I did Mine!
The Brackets I Made >>> By going to Home depot, They sell Billet stock! Then I bent the Aluminum & Drilled the Holes were needed! The stuff I bought was 1 1/4 inch wide by 8 foot & I cut it to Lenght!
The Flow Diagram goes from the Pump Out to the Stock Heat Exchanger In>>>> Then to the Dual Pass In or what ever>>> Then Back threw the Intake manifold Center Port( If running the Dual Pass!
Thread
Thread Starter
Forum
Replies
Last Post
2.0 LSJ Engine: aem wideband,zzp front mount exhanger,stock exchanger
n20saturn
Parts
7
Sep 30, 2015 12:26 AM
