Exhaust size
Exhaust size
Senior Member
Joined: 08-28-05
Posts: 2,862
Likes: 1
From: Oshawa, ONT
Originally Posted by NJHK
Any good welder can make it fit on your stock exhaust piping, which is about 2".
Actually it's closer to 1.75inches. Look where the muffler is connected, it's very small.
see....
Senior Member
Joined: 01-05-06
Posts: 10,877
Likes: 2
From: East Brunswick, NJ
Originally Posted by RedBaseBolt
Actually it's closer to 1.75inches. Look where the muffler is connected, it's very small.
see....
see....
Yeah, I figured it was like 1.75 but I just rounded up.
Thread Starter
Senior Member
Joined: 06-06-06
Posts: 2,889
Likes: 0
From: Redding, Nor-Cal.
Ummm yea its going to a muffler shop hopefully this next week its gonna take a little more than just cutting the other one off and welding this one on. But oh well it will be nice in the end.
Senior Member
Joined: 01-05-06
Posts: 10,877
Likes: 2
From: East Brunswick, NJ
Originally Posted by red06LS
Ummm yea its going to a muffler shop hopefully this next week its gonna take a little more than just cutting the other one off and welding this one on. But oh well it will be nice in the end.
Senior Member
Joined: 01-05-06
Posts: 10,877
Likes: 2
From: East Brunswick, NJ
Originally Posted by red06LS
Verry true, but thanks for all the info. This site is great.
If you want another place for good info and good people, check out ecotecforum.com
Good Luck.
Thread
Thread Starter
Forum
Replies
Last Post