Hi! I will install my oil pressure gauge this week and I know I need to place it on the block to read the right pressure.

My question is, when I'll replace the stock pressure unit on the head, do I need to splice the electrical wiring to a new place or will I have enough long of wiring to run It to the new emplacement (the head) ??

And if I need to cut the stock electric harness and mount it to a new place, where would be the best place ?

Thanks for the help guys!!

 

Someone can help me?

 

Again, nobody can help me ? I need to know!

 

try yc

 

yc ? I don't get it, could you explain please ? Thanks!

 

There is a how-to on here, You need an adapter Gm sender comes out and you leave the GM wiring alone. Takes like 2 min

https://www.cobaltss.net/forums/how-...balt-ls-26929/