I know they have lights for the SS style rear bumper, that are led's, they have a ring on the out side and leds that have to be customly wired in for the middle, so they kinda gives that skyline or corvette look, there pertty kool. i just ordered some off ebay cause they were cheaper than buying them from cobalt-addiction

 

^^^^^ link

 

there on this page for cobalt addiction they can be found on ebay but rarely

http://cobalt-addiction.com/exterior.htm

 

damn too bad they look so flashy. ive been looking for a while for something that would allow a outer ring of light for the outside lights

 

ya im definately not digging any of the aftrermarket lights, and i hate the blackout look. i'll probably just stick with my factory lights for now... until i get bold enough to take them apart and wire some leds or something... just not sure.

 

Thanks for the replies guys... I was just wondering if any had specifically been created for the two larger outer lights; apparently not.

 

Do it, it's easy as hell.

 

were you get your led's for the inner lights?

 

www.oznium.com get the 19" red strips and trim them down unless you want a small gap cause the 9.5" ones won't go all the way around the lens.

 

your not the first person to say oznium so i guess thats what i'll do.

 

How do you have those wired? Just to the running lights or to the tail on each side Corvette style?

 

Running lights and brakes. They function just like the outer lights, except they don't blink with the signals.

http://www.youtube.com/watch?v=L8DE6WtUm-I

 

Yeah I found the vid and see how you did it with diodes and resistors. Very nice setup.