Ok so I recieved my CF gas door today (thanks to tsa_performance) and was just wondering if i could get some help from someone who has done this install.

It appears to be held in with rivets, so my question is if i drill these out what can i use to hold the new door in since i dont the tool to use rivets?

Also i searched for an install howto but never came up with anything.

I appreciate the help
David

 

off topic, hows that ebay short shifter?

 

screws should work fine

 

GO buy a pop riveter they are cheap(home depot) do not use screws

 

Man you know what everyone talked **** to me about buying the ebay version over the TWM. Saying that it wasnt worth a **** and wasnt going to last. Its been about 30k miles and i tend to drive/shift hard from time to time and not once have i had a single problem with it.

So I guess ill be getting a riveter. But what's wrong with putting a short nut/bolt in there instead? Doesnt seem like it would hurt much to me