cant figure it out. replaced the TOB and the hose from the TOB and bleeder. everthing is tight and i didnt forget to put the rubber nipple on the top of the hose but still leaking. anyone have any clue whats going on.

 

seal maybe on the quick disconnect is leaking or missing

 

Checked them both. Both look good but who knows I might just have to take it in to get fixed.

 

you have to push pretty hard on the little distribution block before you put on the snap ring to make it seat properly. try re seating the dristribution block into the trans and clean the o-ring and the hole it goes into.