Dyno
#1
New Member
Thread Starter
Join Date: 05-21-09
Location: Michigan City IN
Posts: 67
Likes: 0
Received 0 Likes
on
0 Posts
Dyno
2.8, 60s, ZZP S3HE, dual pass, ZZP midlength with 2.5 exhaust and ZZP stage 1 cams.
Did a few pulls and its not completly dialed in. put down 282 and 276. Runs were only up to 7300rpm. Only have the graph of the last pull of the day.
No meth, pump gas and 0 KR. Still need some more fine tuneing but I am happy with the results so far.
Did a few pulls and its not completly dialed in. put down 282 and 276. Runs were only up to 7300rpm. Only have the graph of the last pull of the day.
No meth, pump gas and 0 KR. Still need some more fine tuneing but I am happy with the results so far.
Last edited by Chord; 02-20-2011 at 09:40 PM.
#4
New Member
Thread Starter
Join Date: 05-21-09
Location: Michigan City IN
Posts: 67
Likes: 0
Received 0 Likes
on
0 Posts
I have had the cams for about a week. I thought about going with the stage 2 cams, but then I would have had to do shafts and I wasnt sure I wanted to tke the low end hit that the stage 2s have. The stage 1s are a nice power bump and for the most part they dont change the cars street manners too much.
#5
I have had the cams for about a week. I thought about going with the stage 2 cams, but then I would have had to do shafts and I wasnt sure I wanted to tke the low end hit that the stage 2s have. The stage 1s are a nice power bump and for the most part they dont change the cars street manners too much.
on a seperate note, how are those stage 1 axles doing on those hoosiers?
Thread
Thread Starter
Forum
Replies
Last Post