tylerjclance

iTrader: (7)

ScanXL..
The software says my max hp and tq is 171 and 164 respectively..
This seems pretty low for what I have..

2007 ss/sc
meth
zzp pcm
vibrant header, vibrant catted dp, vibrant exhaust
injen cai
(stock pulley on the m62)
60#hr injectors.



I would guess that the software is obviously "estimated calculated wheel horsepower" and there are a lot more variables on the street than on the dyno..

but over a few pulls 2nd and third gear.. I would ASSUME i should be at least at 220 whp...

TO be off by 50 is a lot., considering stock ss's put down at least 215 to the wheels in most cases.


Has anyone else had similar results with data logging software and then went and got an actual dyno and had much better results?
I don't want to be disappointed if and when i go to a real dyno and get similar numbers..


need compression test...

(no KR, no misfires)

DarkChild

iTrader: (2)

You'd be surprised at how junky those basemaps are. The software isn't that accurate either, I would assume. Do you plan on getting a smaller pulley? Why do you have meth and 60's?

vahdyx

iTrader: (7)

Yeah, I did my dyno wrong and got a bunch of wheel spin and it said i was 445whp one day. So I said screw this, it's not accurate.

I tried it again later that week and it said I was 330whp, and according to my superflow I was 310whp

tylerjclance

iTrader: (7)

I have a 2.6 but it's not on. I don't have the tool to put it on.

I was going to order the tool, but i'm ordering a tvs in a month.