I recently wired up a N2MB WOT Box on my 2006 SS/SC. I went to test the box as instructed by turning the ignition on without starting the car and pushing the gas pedal to the floor. When I turn the ignition on the blue LED comes on like its supposed to but does not flash when I push the Gas to the floor. Pushing the clutch pedal to the floor does not effect the LED as well. I have triple checked my wiring and everything checks out. Also my computer cannot see the box when I plug it in even though I have selected the right COM port (COM7). Any ideas as to what could be going on? Any help is much appreciated! Thanks

 

How did you connect the wires?

 

All joints were soldered and heat shrunk. All connections Ohm out.

 

hmm i don't remember doing that test lol does the car actually start or no? it would be worth simply trying when the cars on to me. definately triple check the connection to the ecm to be sure you got the right wire though that was tricky

 

That is what N2 suggests doing to test the box as part of the instructions. Car starts, wiring is perfect.

 

You have to check a box in the programing to reverse the pedal output

 

I would do that but my computer can't find the WOT box. It won't let me check any of the boxes or make any changes.

 

Can't find the box? Reinstall driver software.

 

Tried that.

 

Ok, so this may sound dumb but, make sure your key is on before you try to find the driver/box. It won't work with no power to the accessories.

 

Yep ignition was on.