Ok, I installed an in dash monitor, I used the wiper fuse for the 12v and grounded it to the metal piece on the drivers side panel. I wanna install some sun visor monitors, my question is, is it ok to the use the wiper fuse for the visor monitors also without blowing it?

 

anyone?

 

Totally going to depend on how many amps those specific monitors draw...

 

You can always hook them up through a relay if you're worried about drawing too much amperage.....

 

right... or you could hook them up to the sunroof fuse

 

id hook em up to the sun roof fuse... use a fuse tap, it provides a clean install.

 

go to the bcm I think it is the red/white wire the fat one it is 40amp than you then nothing to worry about