anyone run a to4e 50 trim?
#1
Member
Thread Starter
Join Date: 07-21-11
Location: New Hampshire
Posts: 376
Likes: 0
Received 0 Likes
on
0 Posts
anyone run a to4e 50 trim?
I was curious if anyone runs a to4e 50 trim.
I recently did a turbo swap on my 07 lsj.
The kit i bought came with a 50 trim, .63 hot side.
I know this turbo is supposed to be a little laggy compared to the .43 hot side 50 trim,
but i feel like i dont have much boost/power low rpm. Low end torque feels bad!
At 4k, it boosts to about 9psi
by 5k, right below 19 where it dumps.
Does this seem right? Any input would be appreciated.
-to4e 50 trim .63 a/r
-Siemens #60s, HP tuned (not an aggressive tune)
-zzp bov
-2.5" ic system
-cheap 38mm wastegate w/ voodoo boost controller
-2.5" exhaust (i know, small)
-
I recently did a turbo swap on my 07 lsj.
The kit i bought came with a 50 trim, .63 hot side.
I know this turbo is supposed to be a little laggy compared to the .43 hot side 50 trim,
but i feel like i dont have much boost/power low rpm. Low end torque feels bad!
At 4k, it boosts to about 9psi
by 5k, right below 19 where it dumps.
Does this seem right? Any input would be appreciated.
-to4e 50 trim .63 a/r
-Siemens #60s, HP tuned (not an aggressive tune)
-zzp bov
-2.5" ic system
-cheap 38mm wastegate w/ voodoo boost controller
-2.5" exhaust (i know, small)
-
#7
Member
Thread Starter
Join Date: 07-21-11
Location: New Hampshire
Posts: 376
Likes: 0
Received 0 Likes
on
0 Posts
Yes. When I first built it, I put the ring in backwards. So it dumped all the time.
I mean it builds a lot of power once it spools. The low end boost/torque is just trash
I mean it builds a lot of power once it spools. The low end boost/torque is just trash
Thread
Thread Starter
Forum
Replies
Last Post
Delta coupe
Pictures & Videos
1
09-30-2015 08:11 AM