I know most of you are going to say HPTuners!!! but thats way to expensive im interested in diagnosing..

www.autotap.com

www.myscantool.com

Proscan seems to offer some cool features: you can do dyno pulls along with 60ft times and 1/4 miles times etc. and get tons of diagnostics for under 200 bucks

does AutoTap give you a Air/Fuel ratio readout??????

 

bump!

 

I have played with autotap a little bit. Pretty simple to use but I dont know a ton about it though. Proscan though I have never seen before.

 

I had ProScan and got rid of it when I got HPT. It was alright. The 1/4 mile thing is cool. I used to mess with that a lot. Good features within it. I wish I still had it cause I sold it cheap.

 

i dont know anything (or much) about tuning, i figure this would be a good way for me to get used to scanning parameters and such. whatda think?

 

did the proscan read air fuel and knock?

 

It looks like AutoTap can read a/f and knock, while proscan cannot read knock.

 

yeah thats what it looks like, but you dont need a wideband to read the air fuel wit the autotap??

 

does anyone know......if i were to buy autotap, then i wanted all the extra GM parameters it looks like its going to cost close to 300 bucks for that i might as well get HPTuners