Hey guys I purchased my Balt 5 yrs ago just made my last car payment so now it's time to start the mods!!!! I started with the GM stage 2 kit a few weeks ago & could already tell a huge difference in HP it feels like a whole new car again! This week I'm taking her in for a Injen cold air intake. I went with the Amsoil dry filter for low maintance & to prevent any gunk getting into my throttle body from the oiled filters. I also paid a little extra for the hydro shield in order to keep water & debris out of my engine. While I have her in the shop for the intake Im going to have my tech install a new inter cooler pump as I'm sure mine hasn't worked for some time now. After the air intake & the factory inter cooler is up & running I was going to go with the in galls torque damp & then move on to zzp headers & maybe a down pipe. Then onto the Megan racing cat back & a triple gauge stack to seal the deal!

 

I personally would go with the ZZP 3inch intake over the injen

 

I have an ingalls I will sell you.

 

Welcome to Cobalt land, Once you enter there's no escape.