Mark this thread as Unsold
FS: Mounts, Grille, Rear Brace...etc.
Thread Starter
South Central *********
iTrader: (9)
Joined: 05-14-05
Posts: 6,148
Likes: 48
From: Texas
Fs: Poly trans mounts, mm, tail light, pullies
Well i am trying to move some of my parts to help finance my build, so help me out
Please send PMs as these threads can get buried in the classifieds section.
INTENSE poly mounts- already pressed into stock mounts - less than 10K on the, ready to install * NO WHEELHOP* - $130 SHIPPED IN US
GM lower grill for SS - SOLD
Torque Forward Rear Brace- SOLD
05 LSJ Stock upper motor mount less than 15K miles $25 shipped
Cobalt Rear taillight Coupe just have LH side $20 shipped
I also have:
*(2) Stock pullies for the M62 ill ship them for dirt cheap
*GMPP stage 2 pulley w/o hub for cheap
Let me know if your looking for other parts (especially ECOTEC specific bolts or fasteners), i may have more that isnt listed
please excuse the multiple posts...database error strikes again!!!
Please send PMs as these threads can get buried in the classifieds section.
INTENSE poly mounts- already pressed into stock mounts - less than 10K on the, ready to install * NO WHEELHOP* - $130 SHIPPED IN US
GM lower grill for SS - SOLD
Torque Forward Rear Brace- SOLD
05 LSJ Stock upper motor mount less than 15K miles $25 shipped
Cobalt Rear taillight Coupe just have LH side $20 shipped
I also have:
*(2) Stock pullies for the M62 ill ship them for dirt cheap
*GMPP stage 2 pulley w/o hub for cheap
Let me know if your looking for other parts (especially ECOTEC specific bolts or fasteners), i may have more that isnt listed
please excuse the multiple posts...database error strikes again!!!
Last edited by JapEatr; Jul 23, 2009 at 02:44 PM. Reason: Automerged Doublepost
Thread Starter
South Central *********
iTrader: (9)
Joined: 05-14-05
Posts: 6,148
Likes: 48
From: Texas
PMs replyed.
the bar was a prototype for them i think they made like 15 of them as testors and then they fell off the map.
decent product, you can tell it was not a finished good, but i have had it on my car for like 3 years without a problem.
the bar was a prototype for them i think they made like 15 of them as testors and then they fell off the map.
decent product, you can tell it was not a finished good, but i have had it on my car for like 3 years without a problem.
Thread
Thread Starter
Forum
Replies
Last Post