As the title said, I am looking for the following 3 parts ASAP! I am ready to tackle my injectors to make sure that my cat warm up mode misfires are not due to possible orings or teflon seal since I did use e85 all last summer through fall.

Part number EN-48266 by kent Moore (injector installer/sealer)

Fuel injector seal kit which include(teflon seal, spacers, clips, o-ring, etc..)GM part number 12618798 and optional AC delco part number 217-3096

GM part number 12591003 fuel injection crossover tube pie

Please check the part number before you say you have it.

Thanks! I am located in maryland so if you are local that would be even sweeter

PM me please.

 

buy it new. i doubt ur gonna find someone selling these things

 

yhea..look like Im going to have to buy new, but I know there has to be somebody here that at least have the teflon seal sizer/installer...

anyone know who has these parts cheapest? I'm not even sure if my injectors are at fault here so I just hope this is not a waste of time and money..

 

i just posted a link a few minutes ago but check ebay you can get it new for like 20-30 bucks.
but if you are tuned why not just get cat warm-up deleted

 

jacblack, where's the link? could you pm me please. I been checking ebay and can't find anything.

you are right...I could just have the cat warm up mode turned off but I just dont feel right band aiding the issue. what if my injector seals are really bad? I would like to be sure my injectors are fine since that's the only thing I didnt check. I am really hoping its my injector seals since I was running e85 last year for a few months. I never hoped for a part to be bad LOL. I been chasing this for months!

 

no i posted a pic for a new one not from ebay so i was a little more (Kent-Moore EN-48266 Injector Seal Installer / Sizer)

12618798 - GM SEAL KIT or give the part number to CED to see if they can get it cheaper

these parts are going to have to be special ordered to be honest, i would try and contact mongorat another member on here he always has parts laying around

 

I can't believe theres no teflon seal sizer on ebay. there were tons when I wasn't looking, but as soon as you need one there's none. to pay 130 new from a retailer I might as well just buy new injectors and dont have to deal with installing any seals. I did get a message back from ccss3. His method seem doable but something to think about.

Thanks...jac. I guess I will keep looking around until I get lucky.

 

Def doable.. lol ......

 

thank you brother Im going to look around a little more but if I have to end up paying 130 bucks for the sizer than I will most definitely try your method first.