CobaltSS 16 TVS Build Thread
Essentially "done". just needs some fine tuning, but is running great.
I have just over 1k miles on it now. Next spring im finishing the gut, and working on getting the exterior back up closer to par
I have just over 1k miles on it now. Next spring im finishing the gut, and working on getting the exterior back up closer to par
Nothing too exciting.
Put my winter setup back on... still pretty aggressive fitment lol.
Lowered the rear another 1/2" on each side. Officially the lowest I'm going to go and really want to go (coils are maxed all around with all locking rings out and perches removed.) Now I am rubbing again in the rear.
Getting tints tomorrow. Should look nice.
I will also be getting my rear fenders pulled or installing shims in the rear for -1 degree of camber. Don't worry... I will not turn into a crazy stanced balt, just need a little tire clearance at this point so I don't rub. Going to try and pull the fenders first so I don't have to mess with the camber.
Planning on a purchase of my return style within the next week... hmmm black friday dealz??
List of things I need to do before I mount my TVS:
1. Fix my damn P0449 code - emissions evap code
2. Replace my POS ZZP resonator - its my 3rd one. Don't think I'm going to get another zzp resonator. Looking into a vibrant ultra quiet resonator. My header/downpipe is vibrant and top quality (been running it for 7 years with no problems.) Just need to measure it again because it may be 1/2"-1" to wide I don't know if it will hit the heat shield.
Put my winter setup back on... still pretty aggressive fitment lol.
Lowered the rear another 1/2" on each side. Officially the lowest I'm going to go and really want to go (coils are maxed all around with all locking rings out and perches removed.) Now I am rubbing again in the rear.
Getting tints tomorrow. Should look nice.
I will also be getting my rear fenders pulled or installing shims in the rear for -1 degree of camber. Don't worry... I will not turn into a crazy stanced balt, just need a little tire clearance at this point so I don't rub. Going to try and pull the fenders first so I don't have to mess with the camber.
Planning on a purchase of my return style within the next week... hmmm black friday dealz??
List of things I need to do before I mount my TVS:
1. Fix my damn P0449 code - emissions evap code
2. Replace my POS ZZP resonator - its my 3rd one. Don't think I'm going to get another zzp resonator. Looking into a vibrant ultra quiet resonator. My header/downpipe is vibrant and top quality (been running it for 7 years with no problems.) Just need to measure it again because it may be 1/2"-1" to wide I don't know if it will hit the heat shield.






