ok, I ordered a straight cut tip for my GMPP exhaust but which do you all think looks better?

Straight Cut
http://www.crateenginedepot.com/stor...P1383C144.aspx

Angle Cut
http://www.crateenginedepot.com/stor...P1380C144.aspx

 

i say save the money and get an exhaust system. those are freaking expensive for tips. if i had to choose from those two tips though i'd choose the angled one.

 

I did, You have to pick a tip. Angled or Straight.

 

I voted for the angled one. It's a very small angle and looks good. The straight cut just doesn't provide any flare; straigh cut looks like run of the mill tip; looks cheaper in my opinion. I was considering the purchase of the Flowmaster double walled rolled 4" outlet tip with the 2.5" inlet when I install the Super 40. Here's a link to the Flowmaster accessories page http://flowmastermufflers.com/accessories.html scroll down and you'll see the tip I am talking about p/n 15365.

Scott

 

The more I think about it, The more I want an angled tip. I never noticed that the stock one was angled. Maybe I can change my order.

 

I like them both a lot, but I guess I like the angled one a little better. Are these 4" tips bigger, smaller, or the same size as the stock tips?

 

Angled looks the best

 

angle cut

 

Angle

 

Angle, it looks awesome, and it is about 3/4" larger. It fits over the stock tip.

 

I'm gonna go against what everyone else is saying and say Straight.

I like the straight better personally.

 

i know this is kinda off subject but can you use the tip that comes stock on the ss for the gmpp
http://www.crateenginedepot.com/stor...P1234C109.aspx

I dont know if i want a 4" tip on my ls. I also know that it says that it only fits stock exhuast, but doesnt the gmpp use the same size piping as stock.

 

would the corvette exhaust tip work for any of those systems