I found out mine somehow ripped off, most likely because I over tightened it. anyone know the exact size of this nut? It's lost on the open road now and my endlink is ziptied in place.

 

bump

 

its either a 15mm or 17mm. I think I used a 15mm wrench to hold link from spinning and the nut was 17mm but i forget. Look at the other side?

 

okay thanks, ill buy both from the hardware store. like 10 cents a piece

 

Don't over tighten this time lol jk

 

not going to lie, I tightened the **** out of them...

 

Just bustin ya ***** either way

 

Probably should get the tread pitch. I have no idea what it is. And can you please post a picture of the nut ripped off? I don't believe the nut broke off maybe loosened. LOL

 

You live in Madison Ohio? Ever see a Blue Yamaha Blaster 4wheeler with a stretched rear end? That was my baby. I miss it.

 

I didn't noticed the thread stripped on the endlink, one day I was turning my wheel and I heard a "POP" I was like but didn't think of it until the endlink started rubbing on the control arm.

 

Yes I do & no I haven't seen it around, then again I grew up a city away so when I used to ride I didn't do it w/anyone out here lol. Moved out here because lake county is a better area then ashtabula county.
BTW I like your name

 

My name?

 

Your name is the same as mine
Greg I would assume from your screen name on here correct?

 

O haha yessir it is Good name.