South Mountain UT, AZ, NM, and CO

Arizona BS Thread

Thread Tools
 
Search this Thread
 
Old Aug 8, 2011 | 07:33 PM
  #15251  
1LowLS's Avatar
Senior Member
 
Joined: 02-16-10
Posts: 8,383
Likes: 1
From: Queen Creek,AZ
pulley up? no thanks.I would rather run the risk of blowing on E85 and 2.9 then buy a larger pulley.
Reply
Old Aug 8, 2011 | 09:46 PM
  #15252  
SlowCobaltSS's Avatar
Senior Member
 
Joined: 04-16-11
Posts: 2,909
Likes: 0
From: Hot Arizona
WTF is all I could say when I saw this ad on craigslist

2005 Chevy Cobalt SS
Reply
Old Aug 8, 2011 | 11:32 PM
  #15253  
Tomtwtwtw's Avatar
Senior Member
 
Joined: 03-30-06
Posts: 5,489
Likes: 0
From: Chandler, AZ
That's the new design. You just add water and it fluffs right out to normal size.
Reply
Old Aug 8, 2011 | 11:54 PM
  #15254  
drewbroo's Avatar
Premium Member
iTrader: (2)
 
Joined: 12-21-08
Posts: 5,036
Likes: 0
From: TUCSON AZ
Originally Posted by slowcobaltlt
wtf is all i could say when i saw this ad on craigslist

2005 chevy cobalt ss
clean title!
Reply
Old Aug 9, 2011 | 12:07 AM
  #15255  
SlowCobaltSS's Avatar
Senior Member
 
Joined: 04-16-11
Posts: 2,909
Likes: 0
From: Hot Arizona
I know I saw that
Reply
Old Aug 9, 2011 | 12:17 AM
  #15256  
AzCobaltMan's Avatar
Senior Member
 
Joined: 07-20-08
Posts: 818
Likes: 0
From: Arizona
Originally Posted by drewbroo
clean title!
The title is in a envelope in a desk, making it clean, the car is the bad part lol im bored
Reply
Old Aug 9, 2011 | 12:20 AM
  #15257  
SlowCobaltSS's Avatar
Senior Member
 
Joined: 04-16-11
Posts: 2,909
Likes: 0
From: Hot Arizona
Originally Posted by AzCobaltMan
The title is in a envelope in a desk, making it clean, the car is the bad part lol im bored
Lets go drag race down the freeway haha
Reply
Old Aug 9, 2011 | 02:16 AM
  #15258  
AzCobaltMan's Avatar
Senior Member
 
Joined: 07-20-08
Posts: 818
Likes: 0
From: Arizona
oh that would be a horrible race lol my stock 2.2 would just turn itself off. =)

ORRRR we could go find some rednecks in a v8 ram and ill run them in my stock 2.2 and film it



id drive a lot and never see and css guys around.
Reply
Old Aug 9, 2011 | 02:28 AM
  #15259  
SCcobaltSS's Avatar
Senior Member
iTrader: (2)
 
Joined: 11-28-06
Posts: 4,085
Likes: 2
From: Phoenix
So I just got the seal put on my intake manifold and holy ****!!!!!! She is alive!

Damn though. Way different low end than twincharged.... other than that nothing really. I was at 50% throttle and it got to 3 psi then at about 3k it started to spool! got to 8 quick and it pulled. lol. Feels good to have her running...

Again, I blame Steve, for my car being down, for not elaborating the fact I needed the 2.2 intake manifold seals.

But seriously, thanks for the suggestions.
Reply
Old Aug 9, 2011 | 02:29 AM
  #15260  
Tundraboarder666's Avatar
Senior Member
 
Joined: 08-23-07
Posts: 5,265
Likes: 1
From: Chandler AZ
Woooot!
Reply
Old Aug 9, 2011 | 02:38 AM
  #15261  
SlowCobaltSS's Avatar
Senior Member
 
Joined: 04-16-11
Posts: 2,909
Likes: 0
From: Hot Arizona
Originally Posted by AzCobaltMan
oh that would be a horrible race lol my stock 2.2 would just turn itself off. =)

ORRRR we could go find some rednecks in a v8 ram and ill run them in my stock 2.2 and film it



id drive a lot and never see and css guys around.
Theres probably alot of rednecks around here in v8 dodge ram trucks
Reply
Old Aug 9, 2011 | 06:40 AM
  #15262  
08ssedan's Avatar
Senior Member
iTrader: (1)
 
Joined: 08-03-09
Posts: 5,108
Likes: 0
From: North Phoenix
Originally Posted by SCcobaltSS
So I just got the seal put on my intake manifold and holy ****!!!!!! She is alive!

Damn though. Way different low end than twincharged.... other than that nothing really. I was at 50% throttle and it got to 3 psi then at about 3k it started to spool! got to 8 quick and it pulled. lol. Feels good to have her running...

Again, I blame Steve, for my car being down, for not elaborating the fact I needed the 2.2 intake manifold seals.

But seriously, thanks for the suggestions.
Congrats chris!
Reply
Old Aug 9, 2011 | 08:25 AM
  #15263  
sundevil07's Avatar
Senior Member
iTrader: (1)
 
Joined: 02-03-09
Posts: 4,881
Likes: 0
From: Phoenix, Arizona
Originally Posted by SCcobaltSS
So I just got the seal put on my intake manifold and holy ****!!!!!! She is alive!

Damn though. Way different low end than twincharged.... other than that nothing really. I was at 50% throttle and it got to 3 psi then at about 3k it started to spool! got to 8 quick and it pulled. lol. Feels good to have her running...

Again, I blame Steve, for my car being down, for not elaborating the fact I needed the 2.2 intake manifold seals.

But seriously, thanks for the suggestions.
finish it!!
Reply
Old Aug 9, 2011 | 08:43 AM
  #15264  
FF_ace's Avatar
Senior Member
 
Joined: 10-08-06
Posts: 3,043
Likes: 0
From: Scottsdale, AZ
You need to change your sig cris lol
Reply
Old Aug 9, 2011 | 09:46 AM
  #15265  
SCcobaltSS's Avatar
Senior Member
iTrader: (2)
 
Joined: 11-28-06
Posts: 4,085
Likes: 2
From: Phoenix
Thanks guys, almost done... And I know nick.
Reply
Old Aug 9, 2011 | 10:37 AM
  #15266  
SCcobaltSS's Avatar
Senior Member
iTrader: (2)
 
Joined: 11-28-06
Posts: 4,085
Likes: 2
From: Phoenix
well I went WOT just to feel the car and it hit a brick wall at about 5 psi. I think I dipped below 9 afr (gas correction) and I think that is why. I still have the rich tune on since I was trying to compensate for the vacuum leak. lol. I will lean it out for the way home and try it again.
Reply
Old Aug 9, 2011 | 05:56 PM
  #15267  
1LowLS's Avatar
Senior Member
 
Joined: 02-16-10
Posts: 8,383
Likes: 1
From: Queen Creek,AZ
Originally Posted by AzCobaltMan
oh that would be a horrible race lol my stock 2.2 would just turn itself off. =)

ORRRR we could go find some rednecks in a v8 ram and ill run them in my stock 2.2 and film it



id drive a lot and never see and css guys around.
Im a LS! Wanna run em?

Originally Posted by SCcobaltSS
So I just got the seal put on my intake manifold and holy ****!!!!!! She is alive!

Damn though. Way different low end than twincharged.... other than that nothing really. I was at 50% throttle and it got to 3 psi then at about 3k it started to spool! got to 8 quick and it pulled. lol. Feels good to have her running...

Again, I blame Steve, for my car being down, for not elaborating the fact I needed the 2.2 intake manifold seals.

But seriously, thanks for the suggestions.
your welcome you just didnt pick up what I was laying down
Reply
Old Aug 9, 2011 | 08:31 PM
  #15268  
sfwg's Avatar
Senior Member
iTrader: (1)
 
Joined: 04-19-08
Posts: 533
Likes: 0
From: oro valley az
whos goin to the pavs this weekend?
Reply
Old Aug 9, 2011 | 09:37 PM
  #15269  
Lschima's Avatar
New Member
 
Joined: 06-24-11
Posts: 50
Likes: 0
From: Goodyear
Hmmm I wanna race someone with my stock 2.2!!..
Reply
Old Aug 9, 2011 | 10:29 PM
  #15270  
Tundraboarder666's Avatar
Senior Member
 
Joined: 08-23-07
Posts: 5,265
Likes: 1
From: Chandler AZ
You can race my 2.2
Reply
Old Aug 9, 2011 | 10:32 PM
  #15271  
krizlx's Avatar
Senior Member
iTrader: (4)
 
Joined: 02-24-10
Posts: 4,081
Likes: 0
From: Glendale, AZ
Originally Posted by SCcobaltSS
Thanks guys, almost done... And I know nick.
Im down to hook you up with a sig

Robert! hit me up got a new phone lost all my numbers 6024353092
Reply
Old Aug 9, 2011 | 10:44 PM
  #15272  
1LowLS's Avatar
Senior Member
 
Joined: 02-16-10
Posts: 8,383
Likes: 1
From: Queen Creek,AZ
Originally Posted by Lschima
Hmmm I wanna race someone with my stock 2.2!!..
Originally Posted by Tundraboarder666
You can race my 2.2
And my 2.2!!!!!!
Reply
Old Aug 9, 2011 | 10:46 PM
  #15273  
evofire's Avatar
Senior Member
 
Joined: 07-08-09
Posts: 1,592
Likes: 0
From: Chandler, Az
and my 2.2




who wants to contribute to the "get chris a TVS" fund?
Reply
Old Aug 9, 2011 | 11:12 PM
  #15274  
SlowCobaltSS's Avatar
Senior Member
 
Joined: 04-16-11
Posts: 2,909
Likes: 0
From: Hot Arizona
Umm no one
Reply
Old Aug 9, 2011 | 11:12 PM
  #15275  
1LowLS's Avatar
Senior Member
 
Joined: 02-16-10
Posts: 8,383
Likes: 1
From: Queen Creek,AZ
better get some internals for that TVS.

You do a build with TVS and Ill do a build with the Lysholm
Reply



All times are GMT -4. The time now is 02:09 AM.