His mods: 2.50 axle back, cai, 2.8 pulley, 42s or 60s not sure, zzp s3 h/e and a nice drop on the suspension. my mods are in my sig. keep in mine he is tuned with hpt but without a wideband. he is installing it tomorrow and probably getting retuned sunday than we will re run to see the difference.

2 40 rolls, 1st race i got him by 2 cars and kept pulling by the end of third and 2 seconds in 4th so i stopped.

2nd roll i gave him the jump and got him by 1 and half car. i honestly hope after he is retuned that he hangs with me. the car is clean as hell and wingless.

 

Sweet. Yea hopefully he runs nice and close. An easy win isn't as fun as getting someone in a photo finish.

 

sounds like he needs a better tune

 

the same guy tuned my car so when he gets retuned if he doesnt beat me. my car is a freak of nature. straight up no arguing lol.

 

or you just have a good driver mod

 

where in PA are u located dood

 

Scranton area.

 

ima be in philly tomorrow

 

staged: come up to the meet sometime, if u have fb request Philly car meet as a friend.

blackcobalt: im going up to penn state main to get twisted haha wont be here this weekend. but ill be here for the sunday meet.

 

haha, good ****. theres a meet sunday? what part of philly. if my car test out fine i wouldnt mind going to a meet....mileage depending

 

Hey man thanks for the invite!

I will look into that.

 

northeast philly, right around chickie n petes on the blvd aka route 1 n byberry road. 9 p.m.

 

ill mapquest it

 

This. Pretty tough to tune without a wideband

 

I don't know why people do axle back's ..... When i had my LSJ i measured the inlet of the stock resonator and it was 2 and 1/16th of an inch..... kinda pointless to get rid of the 2.25 restriction going over the axle ... but leaving the stock res on hehe.

 

tell Micheal Scott I said hey.

 

because nobody wants to spend 600 dollars and a stupid cat back system its easier to do a axle back and if u want get a 2.50 inlet/outlet res

 

I got rid of the stock resonator first and welded in a better muffler (muffler). I wonder how much difference a 1/4 inch difference in diameter makes that far back (axle back).

Good run, OP!