Running too lean?
Running too lean?
So my car has been throwing this crap for a little while now... any ideas or suggestions? I erased the code for now since I hate seeing that little yellow icon being on but I'm sure it'll come back soon, it always does.


I would go with either there something wrong with your Maf or connections .The p0102
is whats causing the p0107 most likely due to erratic signal due to a bad connection ,
wire grounding out (or a bad ground connection).
The maf still could be bad but with out a spare you would be guessing so I would check
1)maf connector for corrosion clean contact pin with a contact cleaner and make sure there isnt any moisture in the connector if so seal it .
2)wires leading back to pcm and ground for damage
3)ground connecton for tightness or corrosion (wire rotting off of the crimped connector)
is whats causing the p0107 most likely due to erratic signal due to a bad connection ,
wire grounding out (or a bad ground connection).
The maf still could be bad but with out a spare you would be guessing so I would check
1)maf connector for corrosion clean contact pin with a contact cleaner and make sure there isnt any moisture in the connector if so seal it .
2)wires leading back to pcm and ground for damage
3)ground connecton for tightness or corrosion (wire rotting off of the crimped connector)
i have a fujita intake, and i read somewhere that the angle they put the sensor causes for a false reading, making that cel come up. but my light only comes on like once a month for a day. do you have a short ram or a cold air?
Thread
Thread Starter
Forum
Replies
Last Post



