If you have ever thought about doing this mod but have held back because you would like to see a good write up first, then here's your chance to voice your opinon. Member mggn I believe is that person, check out his billet grille thread and write up https://www.cobaltss.net/forums/show...d=1#post310182 . To give him a little push I'd like to see a showing of hands of guy/gals here who would like to see him do it, I don't know mggn personally but there's no doubt in my mind he would do a great job.

Now I don't care if you even own a Cobalt as of yet ( I don't yet ) but you have thought about doing this mod someday, so let's see those hands that want this done......come on, let's see those hands.

Al

 

Me me me me me

 

I would like to see it too. But, you have to remember its a lot easier on a lift, then on jack stands.

 

Absolutely, even though it would be easier the removel and install would be the same though. Since I've been a member here I've read plenty of post asking for help with this mod, so far there's only been two replies .......if you want something you have to make your wants known...now's your chance.

 

DO IT, DO IT, DO IT!!

 

I'd prefer to see it done on a lift so better pics can be taken compared to jack stands.

Do it!

 

mggn has a lift, from the other write up's he's done I think he would take some great pics. Only five replies so far, it must be everyone else know's how to do this mod without any help.

 

I'd love to see pictures of the process since I plan on doing it soon and I'd like to get an idea of what is involved.

 

If you guys are asking for a how-to on doing springs, I have already written one. It is not published in the how-to section because I need to get some torque specs and details which I should have by Thursday. It's very thorough and has lots of pics. Was that what you wanted?

 

put it in the how to section now, and just update it later

 

Do It Do It

 

Okay, if you insist...

 

Thank you Halfcent you are a great help to us all.