Ok we got a problem
******* rocks!!
Thread Starter
Member
Joined: 08-02-08
Posts: 288
Likes: 0
From: Seven Hills OH
Yea it works now but im getting a check engine light im guessing its because i need that case relearn... But now i have to take the s/c off again because apparently i put the hub to far in and the belt is hanging off by about a mm.... Here we go again. and thanks a lot everyone for all your help you guys rock.
Senior Member
Joined: 11-21-06
Posts: 2,526
Likes: 0
From: San Diego
is the theft light on???
If it is you'll have to do a theft learn......Attempt to start the car, then leave the key in the run position for about 10 minutes (until the security light goes out). Turn the key off, wait a few seconds, then to the run position again. Repeat that cycle a total of 3 times. After the 3rd time, key off wait a minute then start the car.
If it is you'll have to do a theft learn......Attempt to start the car, then leave the key in the run position for about 10 minutes (until the security light goes out). Turn the key off, wait a few seconds, then to the run position again. Repeat that cycle a total of 3 times. After the 3rd time, key off wait a minute then start the car.
good job.
did you paint your rims or get them powdercoated, and if you painted them, what kind of paint and what consistency...semi-gloss, gloss?
Thread
Thread Starter
Forum
Replies
Last Post