I just want to say that the ZZP pully puler is garbage, we broke it about 5 times last night, had to make new screws for the shaft, but after 6 hours, and putting the damn pully on backwards the first time, I am now officially hitting 15 psi with no problems..... it was worth the time....... me and my buddy started at 8 and did not get done until about 2:45 in the morning...... tonight is torque brace time.... i will post pics of everything as soon as i bring my camera in the house

 

nice bro, GL with it and post the gains

 

If I could recommend one pulley puller, it would be the billetflow unit. check this thread out. It was used for over 150 pulley swaps, and is STILL WORKING.

http://www.svtperformance.com/forums...d.php?t=259944

Oh, and doug says the orange and yellow pullies are out getting anodized right now. Within a few weeks I should two vehicles pullied by billetflow!

 

few weeks?


I'll have pulleys mid week... that means you can be pullied by next Friday

 

HELLS YEAH !!!! BTW Doug if you are coming to the michigan meet you should bring some pulleys with you. I am thinking you could sell a couple.

 

when is that coming up?

 

Hopefully, I will have better luck with ZZP's puller next wkend..

 

yay! pullies for everyone!

 

ug 5 times.... :S

 

it will be fine, lots of people have used it with great success including me and many people I know.

 

Ok, sounds good. It seems and looks like a well made puller from my experience. I have read over the directions a few times, so seems like it will be easy....

 

the puller isnt the problem, the big bolt and the little screws are shitty.....