07 Tuners..... :)
07-04-2008, 02:31 PM
#151
Senior Member
iTrader: (1)
Join Date: 07-27-07
Location: Puyallup, WA
Posts: 17,332
Likes: 0
Received 0 Likes
on
0 Posts
yeah the car shot off and came back on and the rev limiter is gone. i can also feel the tranny shift faster than what the bm shift did and doesnt give you that hard kick when shifting. i just didnt feel any strong hp gain. im assuming the 2.4 intake mani will bring out the tunes full power as far as bolt ons.
Im trying to get with FaceLessKhaos in getting the 2.4 intake mani and some parts from local stores so we dont have to pay the full 250 or w/e.
He also has a dyno that i will be able to use if i go down to NC.
so im looking around late september sometime october for the dyno and 2.4 intake mani.
oh, i dont want to go over 105 mph cause i have stock tires right now. not trying to blow them up atm
Im trying to get with FaceLessKhaos in getting the 2.4 intake mani and some parts from local stores so we dont have to pay the full 250 or w/e.
He also has a dyno that i will be able to use if i go down to NC.
so im looking around late september sometime october for the dyno and 2.4 intake mani.
oh, i dont want to go over 105 mph cause i have stock tires right now. not trying to blow them up atm
im thinking that depending on gains due to supported mods and what i have seen from other people...i am hoping to be around 190-200whp
07-04-2008, 04:06 PM
#152
Junior Member
iTrader: (1)
Join Date: 03-08-08
Location: Langley AFB, VA
Posts: 425
Likes: 0
Received 0 Likes
on
0 Posts
im going to drag track wendsday and i need a launch tip. should i start off in Drive and rev it to 2k where it stops or stay in neutral, go to about 5k or so then jump to D and floor it?
going to make sure i get time slips there. im going to do 3 runs hopefully.
going to make sure i get time slips there. im going to do 3 runs hopefully.
07-08-2008, 08:55 PM
#153
Senior Member
Join Date: 05-29-07
Location: Beaumont, TX
Posts: 584
Likes: 0
Received 0 Likes
on
0 Posts
got my car tuned and i have the 2.4 intake mani on my balt and the raised rev limiter. it pulls much much harder in the 4500+ rpm range. the PE delay delete is VERY noticable. i think that by taking it off the car feels faster but im not sure how many hps i got from it. i am waitin for my n2o install to get finished up(hopefully this saturday) and then ill be hittin the dyno! as far as the service from vince and the guys at clear image auto i am very pleased with every aspect of buying this tune. id recomend them to everyone wanting to purchase this tune. but now i have to wait til they get the tuner back so the 200 dollar hold on my account goes away hahaha
07-09-2008, 09:48 AM
#157
Junior Member
iTrader: (1)
Join Date: 03-08-08
Location: Langley AFB, VA
Posts: 425
Likes: 0
Received 0 Likes
on
0 Posts
its raised even if you dont have the 2.4 intake mani. mine was restricted to 4k, now it goes to 7k. good to show off when driving by girls. pop N and rev then back to D for a lil burn out.
07-09-2008, 11:33 AM
#158
sweet just got off the phone with vince and now i'm all giddy like a school girl. i'm gonna with a 350hp build on nitrous. My next mods will be a full suspension setup with the ssbc brake swap then i'll do my cams, springs, 2.4 intake mani, rods and pistons so i can run a trackable 150 shot. i'm freaking stoked right now.
Last edited by Spanky's Monkey; 07-12-2008 at 01:16 PM.
