Finally made it to the dyno after 16k solid miles with the m62 installed. Stock pulley, complete stock exhaust, r.a.w. intake, 93 octane, super safe year round tune by member StreetDreamz on here(was driven from -18F to 90F). Made 226hp/198tq first pull, third pull is in picture after a few minor tweaks and still super safe tune. Numbers were 231/205. Took a vid on my phone but turned out crappy. Dynojet with Std CF for those that are interested! Good baseline to start with I figure!

 

not bad at all!

 

Very nice. Time to drop a pulley size.

Post your results in this thread.

https://www.cobaltss.net/forums/dyno-results-170/official-dyno-thread-take-3-a-163306/

 

Done!

 

Haha way to get a shot of my ass hanging out of your car man. For reference I took my Ion Redline there yesterday too and on the stock pulley with just an intake, 42s, header, and my tune it put down 216/182. Not bad for a pretty much stock car on a dynojet. The header is killing my torque I believe but it made a pretty much flat torque curve from start to finish so I am happy about that.

 

It look like your wearing girl shoes and soaks on that shot.

 

Haha yeah they do look like high heels. They are yellow Nike Shox, I have them untied too lol.

And don't forget to mention Brent, I have to put this plug in there, that the install was done by me also last year! Lol.

 

Oh don't worry I've mentioned it several times who did the install, but no problem with one more! Hey if you come across anyone sellin a header/dp or h/e in your area let me know, I'm interested.