need help removing projectors which bolts am i missing? sry ima noob here are pics:

 

you should be good. there are only two bolts that hold the projectors in place. you just have to wiggle them out now

 

what i do is push the inside of the light in and it should pop the outside out and you just pull it from there

 

thx i got it had to take off all the push pins, but i dont see the gold and broze knobs i saw in the how to (for 2nd gen) for adjusting projectors on my 1st gen is this the bolt i need to adjust 1st gen?

there is no sliver and bronze **** on the 1st gen.




only *** I can find!

 

thats it i can't remember which bolt does which there are 2 so you should be good, maybe if theres a how to for the 1st gen cause thats what you have 2nd gen may be dif

 

here a better pic


edit : found both **** dunno which is which thou



anyone know about adjusting 1st gens?

 

you can experiment, i think it might be the left one moves it right to left and the right one moves it up and down

 

thx now I figer out how to take out my headlight, now im going wait till night I tried using a garage but there was too much **** front of the wall to see the alignment. Tonight going drive around till I find a nice flat white wall. thx for all the help you guys rock

 

thats what i'd do, bring some tape to it helped me to mark the lights on the wall

 

good ideal I got painter's tape which will work perfect!

 

there you go good luck man, and let me tell you it will get agrivating, so make sure you figure out which screw does what, turn a little at a time too

 

that what I plan on doing allot work but be worth it, it being uneven bothers me

 

oh beleive me i know lol

 

i fucked with the **** with out looking at the lights today and then I waited till night then went to go find a wall and realize I almost hit it dead on with out looking I was like omfg, it so close not worth the effort to fix it half a inch! I thout my right head light was going be off about a mile to the left ot right.

Before pic:


After:


all I did was turn the left *** 5 times to the right then 10 times to the left lol dunno how I got this close.

I was shocked for getting this lucky

lol my 6000k hid look so white in this pic

 

lol i say this with all due respect. your a bastard lol j/p man nice, i personally would aim them higher though lol

 

thx lol dont want blind people plus if I mess with them again I might have troub getting them perfectly aligned again. I just got lucky this time.