ok folks i got bored today so i decided to install my system into the car.


i started at 2pm and never got out tell 12am... work is gonna hurt tomorrow...


the goodies that went in

SSS600 clarion componets
P.A. 3000D amp for my 2 12" RF HX2's
and some 4 channel audiopipe amp that i think is fried...
deck is already in thier



that little harness made me mad... i couldn't understand what was holding the seat down still... lol


oh my gosh... the car is a mess.


where is my flippen rear seat... :|


oh thier it is. lol


something seams to be missing...


stock or not... kinda hard to tell is it not?



thats all i got for pictures sadly... i got lazy and jsut wanted to finish the install


but somethings not right... my trunk release don't work and i think that amp is fried... :S it work perfectly... tell i tried to put my passenger side seat in...

 

thats crazy, how did u get the seat out.. how many bolts was it? locations?

 

no bolts for the entire rear seats... :| all it was is some push type latchs and a looking type thing for the bottme half. a 20 min job not even to remove the rear seats

 

Dammmmmn, Thanks allot of work. Nice

 

Stage 6 Weight Reduction

Check your accessory fuse under the hood. It should be a 20Amp fuse, I blew mine the other day while I was installing my under-dash lighting. I replaced it with the 20Amp fuse from my non-existant heated seats

 

lol taking the rerar seats si nothing, lol, where has it ripped to is about as lame as a couch lol, now chunk time to rip it down to be dynomatted

 

could you possible take pics, or PM about the clips & locks to remove it?

 

yeah... but igotta either

1: get a sponser
2: ask uncle joey for a nice donation of dynomat (thats you sunfirejoe)
or 3: wait tell next summer to do it

 

yeah, tomorrow i'll get you some pictures


hey joey do you have any amps? i need one A.S.A.P. my front amp is fried i think

 

I might be going to the track on Friday, and I might tear down my car like that for the day to improve my times, just leave the driver seat in

 

yeah it would take you like an hour to do all that. not even

 

lol, uncy joey, is supplying you with a tune to make your car afster, not dynomat, but i knwow here to get ti cheap well cheapish

 

uncle joey wants to make my vcar louder first then faster.

 

YAHOOO my amp works...


i forgto to groud it... well i did, but i guess it was bad spot.

 

I removed mine when I ran the amp wiring. If I remember correctly you have to push in and down on the front of the rear seat to get them to release. Or it might be in and down on the bottom back of the bottom piece to release it. Just push in different places and you'll figure it out......

 

how hard is it to put a new cd player only in? i have one sitting around i should throw it in there

 

not to difficult if you have the harness and the trim piece....if you have onstar/xm/ or steering wheel controls it's a bit more difficult, But still possible. If you need some help I can walk you through it....or we can try and meet up some evening and I can help you.

 

easy as hell man...just get the harness...crimp or solder colour coded wires...run wire to fuse and if ur thinking about putting in an amp someday run some RCA's and a remote wire....
Metra wiring harness is 70-2301...getting the harness was the hardest part for me, not many shops in ottawa have touched cobalts yet

 

I'm in Ottawa myself and about to put a CD player into my Pursuit. Can you tell me where you got it, how much? Also where did you get the mounting kit? Thanks!!!!!!