Just to make sure the LNF needs 65.1mm? and Enkeis are 72.62

 

Let me get it for you but yeah they are 72.62mm OD to 65.1mm ID

 

Found plastic and aluminum ones on ebay. Leaning towards the plastic due to aluminum corrosion issues

 

i got them from amazon and corrosion isnt to big of a problem for me tho

 

Lol yeah a few got all confused

 

I'm retarded then.

 

Lol and its on blue so it attracts attention ^^

 

Should put it over your pic not in text

 

Lol i could do that i guess

 

not like anyone reads mod list/sigs lol

 

Lol that is true

 

Dropped my head off at the machine shop today to take .030" off. Guy looked at me like I was nuts. Should be done tomorrow he says. Stoked!

 

I painted my stock shift knob

 

Got my car back from the body shop again with a new look

 

Fix the fender to headlight gap

 

white bowtie?

 

white bowtie and black bar

 

Got this beautiful bastard back today. $64.99 tax included.

 

Ive tried but it hard to get it correctly lol

And yup black bar and white bowtie to match the paint of the car took it in for some other issues with the front and lower lips and got that painted for free

Also installed my hub center rings and new lug nuts

 

ohhhh shinnny

 

Nice jesse good luck putting it all back together

 

Just shave the head or did you have them clean up the valve seat too?

 

the whole shebang!

 

did you cut off the bosses for the lift point yet? do it now so you don't have to deal with it later.

The front one only needs to be cut if you want to keep the lsj lift point (common knowledge, I'm sure you know), but the one on the side hits the lsj tensioner pulley and needs to be shaved down a bit to clear

 

Just shave. I can clean the seats myself. Not that they need much. I left liquid in the combustion chambers when I got the head for a couple hours and maybe 1cc of liquid leaked