10psi
Thread Starter
Senior Member
Joined: 02-13-08
Posts: 1,126
Likes: 0
From: Davenport, IA
10psi
I just installed a mechanical boost gauge, and went out for a drive.
FYI, I cut into the line on top of the BOV, T'd it.
@ Idle, im sitting at -20ish In. HG.
Under full boost however, I saw it reach 10psi.
Its a Faze Vacuum/Boost gauge. Part # 883104 (www.fazegauge.com)
could it be the gauge, the tune, or the installation?
Im pretty sure all the docs pertaining the kit state 6 or 8psi (cant remember)
2.4L Auto
FYI, I cut into the line on top of the BOV, T'd it.
@ Idle, im sitting at -20ish In. HG.
Under full boost however, I saw it reach 10psi.
Its a Faze Vacuum/Boost gauge. Part # 883104 (www.fazegauge.com)
could it be the gauge, the tune, or the installation?
Im pretty sure all the docs pertaining the kit state 6 or 8psi (cant remember)
2.4L Auto
Former Vendor
Joined: 07-07-06
Posts: 1,430
Likes: 0
From: Chicago, IL
You're fine. The actuator on this system will achieve boost pressures of 8-10 PSI under normal conditions.
For future reference, and fast response, please contact our Tech Support with questions:
Email:tech@turbosystem.com 24/7
Phone: 630-553-1696 M-F 1-5 PM CST
For future reference, and fast response, please contact our Tech Support with questions:
Email:tech@turbosystem.com 24/7
Phone: 630-553-1696 M-F 1-5 PM CST
Thread
Thread Starter
Forum
Replies
Last Post
boosting in Ohio
2.0L LNF Performance Tech
5
Oct 20, 2010 08:46 PM