Appearance: How to Make & Install Lower Grill
#76
Senior Member
iTrader: (1)
Join Date: 06-20-07
Location: in my car
Posts: 6,709
Likes: 0
Received 0 Likes
on
0 Posts
I meant to post this a month ago.
I took my own approach with this one:
It's the only picture I have of it. So far it's holding up PERFECT.
Ignore the bug guts since the car wasn't washed for a few days.
I took my own approach with this one:
It's the only picture I have of it. So far it's holding up PERFECT.
Ignore the bug guts since the car wasn't washed for a few days.
#81
Senior Member
iTrader: (1)
Join Date: 06-20-07
Location: in my car
Posts: 6,709
Likes: 0
Received 0 Likes
on
0 Posts
mine is still holding up well other than needing to be repainted
I've caught just about everything including dragonflies in the grille....well worth the 10 bucks and time to custom fit one
my a/c condensor looks new
I've caught just about everything including dragonflies in the grille....well worth the 10 bucks and time to custom fit one
my a/c condensor looks new
#82
Senior Member
Join Date: 08-31-06
Location: Abilene, Texas
Posts: 4,892
Likes: 0
Received 0 Likes
on
0 Posts
i just did mine...it was 10 bucks at home depot in the "building supplies section" next to the other wire for concrete and things....and all i have to say is, be willing to get sliced and diced ...alot of cuts, but, well worth it
#84
nice how to. i did mine the same way almost. only difference is since the front bumper curves a tiny bit i bent the mesh to fit better...in order to that u have to cut small V shaped piece out of the center where u make the fold in the mesh. Dont notice any difference in looks but its easier to install. Also (i was to stupid to think of this) but my friend used the left over mesh that he cut off and put it where the stock plastic mesh crap is on the back lip. Looks badass
Last edited by Snakes709; 09-05-2008 at 01:14 PM.
Thread
Thread Starter
Forum
Replies
Last Post