I'm Back!!!!
#1
Senior Member
Thread Starter
Join Date: 12-07-05
Location: Indianapolis
Posts: 964
Likes: 0
Received 0 Likes
on
0 Posts
I'm Back!!!!
Hey guys, after a little time off to recoup. I am up and running again. I have a full service shop on my own property. This will allow me to give you top quality service at a fraction of the normal cost. Let me know what you need.
Rob
Rob
#3
your shop is in indianapolis??? hell had i known that i wouldve tried to stop by when i was up there last week.
since your from that area whats with the plant that makes the allisons for the HD's? i heard it was fallin on hard times and may shut down. then what for duramax's, manual only?
since your from that area whats with the plant that makes the allisons for the HD's? i heard it was fallin on hard times and may shut down. then what for duramax's, manual only?
#4
New Member
Join Date: 08-21-06
Location: Fort Wayne, IN
Posts: 98
Likes: 0
Received 0 Likes
on
0 Posts
your shop is in indianapolis??? hell had i known that i wouldve tried to stop by when i was up there last week.
since your from that area whats with the plant that makes the allisons for the HD's? i heard it was fallin on hard times and may shut down. then what for duramax's, manual only?
since your from that area whats with the plant that makes the allisons for the HD's? i heard it was fallin on hard times and may shut down. then what for duramax's, manual only?
Anyway, what is your shop's specialty? I'm down that way every once in a while.
#7
Rob I need help with my pistons, you told me to go with 10:5:1 and now everyones saying different. Let me know what you think and what your plans were. I need to figure out what i'm doing before I start my build.
Thread
Thread Starter
Forum
Replies
Last Post
importkiller
Problems/Service/Maintenance
11
09-30-2015 07:18 PM