2 Stage Photo
#29
Member
Thread Starter
Join Date: 10-01-07
Location: Washington State
Posts: 200
Likes: 0
Received 0 Likes
on
0 Posts
I just used some .115" aluminum 1.25" wide and made a template for the 4 solenoids and one for nthe mounting point then drilled on a press the painted it black. Since then though the paint started to peel and looked like **** so I stripped it off and gave it a brushed finish
#30
Member
iTrader: (1)
Join Date: 02-14-09
Location: fremont ca
Posts: 239
Likes: 0
Received 0 Likes
on
0 Posts
I just used some .115" aluminum 1.25" wide and made a template for the 4 solenoids and one for nthe mounting point then drilled on a press the painted it black. Since then though the paint started to peel and looked like **** so I stripped it off and gave it a brushed finish
#31
New Member
Great pics. I have been paying attention to these and everyones comments. Im already working on a application specific system for you guys with blowers. So far I want a fitting that will fit nice and get rid of the big bend when tapping into the factory fuel system. Then coming up with a nice bracket for solenoids.
These two things make the system much better beside the fact that they will look better, If we know where the fuel is coming from, and we know where the solenoids are going. We can make all custom length lines to make it all fit perfect. We could decide where we want the nozzle and now the whole system would look perfect.
These two things make the system much better beside the fact that they will look better, If we know where the fuel is coming from, and we know where the solenoids are going. We can make all custom length lines to make it all fit perfect. We could decide where we want the nozzle and now the whole system would look perfect.
Thread
Thread Starter
Forum
Replies
Last Post