nice!!

 

how did you guys bleed the system after installing this? I purchased one and plan to run it in line with the stock, but ive never done anything like this before.

 

Could i use the drain as a air bleeder if it was on the top???

 

I think it would bleed it self out eventually I had to add more coolant after my first drive with it installed.. that was after I bled it during installation.

 

Guess my question is...is it safe to just install it and hook it in with the stock H/E and be good?

 

thats how i did mine. Although i had to drill holes in my bumper. It had 2 holes already but they where 2 far apart so i had 2 drill some 2 match it up. i shoulda took some install pics. i did it last week. Next week ill be installing the stage 3 duel pass endplate when it comes in. Ill take some install pics with that.

 

yeah, going through the crash bar wsan't a concern to me..just hooking up the hoses heh. if yours turned out ok then...

 

Just read the comments in this thread and it should make things easier. Worked for me

 

How do you bleed the system?

 

sub'd... mine is coming haha my temps sky rocket

 

Did any of you guys run opt b with the ott unit? If so where the hell does the .040 orifice with the brass fitting go? I bought the opt b kit from crate engine and its purge line do i rly have to drill through the ott h/e?

 

^^^^anyone know?

 

make sure you install this as far forward as you can. My OTTP H/E just rubbed a hole in my AC condenser.

 

subed

 

sub'd