2.0L LNF Performance Tech 260hp and 260 lb-ft of torque Turbocharged tuner version.

Walbro 400lph Fuel Pump?

Old Apr 14, 2012 | 08:31 PM
  #1  
gone_in_10_sec's Avatar
Thread Starter
Senior Member
 
Joined: 10-05-10
Posts: 805
Likes: 1
From: A.B.E. PA & Jacksonville FL
Walbro 400lph Fuel Pump?

Walbro 400lph Fuel Pump - does anyone have one installed or currently using one now?
Reply
Old Apr 14, 2012 | 08:40 PM
  #2  
tomj77's Avatar
Super Moderator
Platinum Member
iTrader: (2)
 
Joined: 07-14-08
Posts: 12,039
Likes: 156
From: canada
What would u need one for
Reply
Old Apr 14, 2012 | 09:09 PM
  #3  
SSlobalt's Avatar
Senior Member
 
Joined: 06-22-09
Posts: 5,989
Likes: 7
From: Kathmandu
For 700 hp.
Reply
Old Apr 14, 2012 | 10:35 PM
  #4  
tomj77's Avatar
Super Moderator
Platinum Member
iTrader: (2)
 
Joined: 07-14-08
Posts: 12,039
Likes: 156
From: canada
ahh lol
Reply
Old Apr 16, 2012 | 11:32 PM
  #5  
gone_in_10_sec's Avatar
Thread Starter
Senior Member
 
Joined: 10-05-10
Posts: 805
Likes: 1
From: A.B.E. PA & Jacksonville FL
I'm going to order it on friday.. I'm hoping to install it before LNF mod day..
Reply
Old Apr 17, 2012 | 02:04 AM
  #6  
FasterIsBetter's Avatar
Senior Member
 
Joined: 05-15-10
Posts: 3,994
Likes: 2
From: South Charleston, WV
Didn't burn up the aeromotive pump did you?
Reply
Old Apr 17, 2012 | 02:05 AM
  #7  
gone_in_10_sec's Avatar
Thread Starter
Senior Member
 
Joined: 10-05-10
Posts: 805
Likes: 1
From: A.B.E. PA & Jacksonville FL
nope just wondering if the walbro 400 pump would provide more fuel on demand when using e85/90 mix..
Reply
Old Apr 17, 2012 | 02:13 AM
  #8  
FasterIsBetter's Avatar
Senior Member
 
Joined: 05-15-10
Posts: 3,994
Likes: 2
From: South Charleston, WV
And I believe you need a pump with the center inlet. I don't think the walbro is offered in that so you'll have to modify your sending unit/fuel pump assembly.
Reply
Old Apr 17, 2012 | 02:14 AM
  #9  
FasterIsBetter's Avatar
Senior Member
 
Joined: 05-15-10
Posts: 3,994
Likes: 2
From: South Charleston, WV
I was wondering cause I'll buy the aeromotive off of you otherwise, lol!
Reply
Old Apr 17, 2012 | 02:16 AM
  #10  
gone_in_10_sec's Avatar
Thread Starter
Senior Member
 
Joined: 10-05-10
Posts: 805
Likes: 1
From: A.B.E. PA & Jacksonville FL
Originally Posted by FasterIsBetter
And I believe you need a pump with the center inlet. I don't think the walbro is offered in that so you'll have to modify your sending unit/fuel pump assembly.
i think the corvette pump assembly is similar, i wouldn't know until i get to work tomorrow.. lol..

most likely im keeping the aeromotive pump for now.. until then i'll try the walbro pump and see if it works with or without modifying the pump assem..

Last edited by gone_in_10_sec; Apr 17, 2012 at 08:31 AM.
Reply
Old Apr 17, 2012 | 09:37 AM
  #11  
gone_in_10_sec's Avatar
Thread Starter
Senior Member
 
Joined: 10-05-10
Posts: 805
Likes: 1
From: A.B.E. PA & Jacksonville FL
The corvette fuel tank module isn't going to work, b/c the white module "cap" [fuel tank door] is too small, but I found the next best thing to work..

The closes one to fit the Walbro 400 FP is a 09-11 Equinox/Torrent Primary Fuel Tank Module.. the module will fit right inside the Cobalt tank.. there is only one problem - on the Equinox/Torrent there is a right side fuel pickup line for the right side tank.. [it's a single tank but the drive shaft hump turns the tank into a dual tank setup]

The fix: Is to either swap out the Equinox/Torrent white module cap with the Cobalt white module cap or
seal the second pickup line with sealant and cap off the outside second pickup line as well..

Also the really neat thing to this setup is the fuel tank module can be also used as a dual fuel pump setup as well.. it has a second pump "seat" for the second fuel pump inside the module "white can"..

Last edited by gone_in_10_sec; Apr 18, 2012 at 10:53 AM.
Reply
Old Apr 17, 2012 | 09:42 AM
  #12  
Gremlin85's Avatar
Senior Member
iTrader: (8)
 
Joined: 08-01-09
Posts: 9,998
Likes: 2
From: Wheh ah we? MA.
Originally Posted by gone_in_10_sec
The corvette fuel tank module isn't going to work, b/c the white module "cap" [fuel tank door] is too small, but I found the next best thing to work..

The closes one to fit the Walbro 400 FP is a 09-11 Equinox/Torrent Primary Fuel Tank Module.. the module will fit right inside the Cobalt tank.. there is only one problem - on the Equinox/Torrent there is a right side fuel pickup line for the right side tank..

The fix: Is to either swap out the Equinox/Torrent white module cap with the Cobalt white module cap or
seal the second pickup line with sealant and cap off the outside second pickup line as well..

Also the really neat thing to this setup is the fuel tank module can be also used as a dual fuel pump setup as well.. it has a second pump "seat" for the second fuel pump inside the module "white can"..
I love information like this!

Thank you!
Reply
Old Apr 18, 2012 | 10:55 AM
  #13  
gone_in_10_sec's Avatar
Thread Starter
Senior Member
 
Joined: 10-05-10
Posts: 805
Likes: 1
From: A.B.E. PA & Jacksonville FL
Originally Posted by Gremlin85
I love information like this!

Thank you!
no problem, just thought it would be neat to share..
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
taintedred07
2.0L LNF Performance Tech
32
May 28, 2022 03:47 AM
no_ss
Problems/Service/Maintenance
11
Oct 18, 2015 11:58 PM
DocSvensk
2.0L LNF Performance Tech
7
Sep 27, 2015 02:24 PM
Adiaz1ss
Problems/Service/Maintenance
4
Sep 26, 2015 11:51 PM
roth
Problems/Service/Maintenance
2
Sep 26, 2015 12:16 PM


Thread Tools
Search this Thread

All times are GMT -4. The time now is 02:37 AM.