I ordered a Injen CAI today and am just wondering how easy it is to be installed.

 

It is not hard at all, you just need a few tools, screw driver, and socket wrench, and some time, just jack the car up, take the wheel well plastics off, and get to install!

 

here is all you need to know in the "how-to" section of this forum.
https://www.cobaltss.net/forums/how-guide-43/injen-intake-installed-2-0-ss-11167/

 

Took a little time just because I wanted to do it right the first time without scratching it. Just follow those directions and you will be fine.

You may want to use some electrical tape on the edges of the car that may scratch.

 

its easy just dont use the spacer they send because its too big and your filter will be pressed against your bumper just use some small rubber washers.

 

I just got my injen tube swapped out for the newer version, used the rubber bushing and it fits like a dream. 100% better than the old model...