first cycle the key to the on position....but you need to be holding the brake at all times....so holding the brake cycle key to the on position....then start the process for the relearn.

 

Bringing back from the dead, but my buddy is trying to do a crack relearn and as we rev'd it up slowly, eventually it will say "rpm too high" and stop the relearn process. We can't get above like 2.5k rpms. Suggestions? I've read through this thread and tried all of them....

 

what are you using to do the relearn? i did mine in my driveway using trifecta ezflash. it gave me some instructions (dont remember what they were) and it worked after 2 or 3 tries.

 

HP Tuners. I've been through their forum. I've googled it. I've used every thread on here and nothing works.