we just replaced the clutch on my 2.4, now clutch is not bleeding, still goes to the floor i have nothing, how else can i bleed the clutch, need help right now please, thanks

 

how is it not bleeding? are you pumping the pedal fast before you started bleeding? you may have aerated the fluid, if thats the case, let it sit for a while till the bubbles calm down.

 

You might not have hooked the Distribution Block up properly... I think I had that problem when I did a transmission swap.

 

When u disconnected the slave did u let all the fluid drain out if so good luck ull have to pull the master and bench bleed it other wise if u didn't pull the cap of the resivor opens the bleeder on the slave and just gravity bleed it

 

its been sitting for a while now, still no fluid draining yet?

we didnt let the fluid drain out, we also havnt tried it with the cap off, im so pissed right now, trying to get this done so i can trade it in tomorrow morning for my 09 ss/tc.

 

Take the cap off and open the bleeder as much as it can it'll work that's how I did mine

 

ok well my dad said that he did that and still nothing, what else can we try???

 

How does ur break pedal feil ?

 

brake pedal feels normal, but i still have nothing for clutch wtf?

 

Go buy a vacum bleeder

 

ok got one today, still didnt work...not a drop came out. so we had our other buddy come over and he tried then said the master cylinder is ****, so now i got to buy that, who sells em just dealership and crate engine depot?

 

That makes no sense that ur master is bad they don't just randomly go bad If u still have brakes there another issue ur over looking bc the clutch and the brakes are all the same hydrolic system

 

dont feel bad mine is doing the same thing now. i have been trying to figure it out for the past week.

 

finally got it fixed today, put a new clutch master cylinder in and good to go now, going to trade it in now $400 later lol