I just installed ottp rotated stage 2 mounts and im still getiing wheel hop. i tried the loosening the engine mounts for everything to settle and leaving the bolts slightly loose so everything can settle even more and its still hopping like a ****.

 

I did the TTR STOP mounts and still had wheel hop even though it was 10x better than the stock mounts. I then purchased the TTR engine mount and it stopped wheel hop on the street but I still have a tiny bit at the dragstrip.

Your next step is to either get an engine mount or ingalls TD.

 

Did you tighten them to the right torq spec? ALSO big tip from when I installed mine. Loosen the 3 bolts on the passenger side engine mount. Let the motor move by itself, then tighten all 3 down again.

 

i loosened the three engine mount bolts for the install and yes i torqued them down correctly its still just as bad as the stock ones

 

what mods do you have? how much power are you making. what axles do you have? what tires? whats the temperature?

 

tire pressure is probably too high too

 

stage 2 cai 2.9 pulley longtube headers catback stage 1 axles and spec stage 3 clutch and i have the stock 18s wrapped in goodyear eagle f1's

 

bump

 

ut oh I'm about to install the Stg1 kit... hope I dont have this problem...